Digital Networkable Public Address

Product Details:

The Digital call station shall be an EN54-16 & ISO 7240 16 certified user interface.It shall be designed in a modern and robust chassis with a graphical display.As standard, the call station shall have a gooseneck microphone with pop shield and permanent monitoring, an illuminated LC-display and an integrated loudspeaker to be used for system soundsIt shall be possible to modify the call station to suit the user’s requirements by connecting up to five remote call station extensions, each with 20 free customizable functions and selection buttons.The Call station shall have a built-in numerical keypad; it shall be possible to enable or disable the keypad during configuration• Five menu/function keys (pre-programmed) – four buttons shall provide each 1 LED (two LED’s shall be 2 green and 2 LED’s shall be yellow).• Green led on the microphone which is active during a call• 15 function and speed dial buttons (customizable), two LEDs (green/red) per button.• Button functions shall be programmable such as:• Zone select, source select, level control, emergency on/off, message on/off, failure acknowledge/reset. • switching output trigger on/off or 0 to 10V, select scheduled events, scheduled event on/off.• CAT5 cable for data and audio connection to controller (can bus, up to 1000 meter).

Product Details:

The call station extension shall be EN54-16 Certified. It shall be designed in a robust and modern chassis. It shall expand the call station by 20 customizable functions keys.• 20 free customable functions keys, and two LEDs per button (green/red).• It shall be possible to program button functions as:• Zone select, source select, level control, emergency on/off, message on/off, failure acknowledge/reset.• switching output trigger on/off or 0 to 10V, select scheduled events, scheduled event on/off.• An LED shall also be programmable for own indication functionality

Product Details:

500W amplifier shall have High efficiency class-D amplifier channel, 
Switched mode power supply,
Local audio inputs,
Mains and battery operation & Complete supervision.
The units should be mounted in a 19"-rack with the included mounting brackets.

Product Details:

Product Details:

EN-54 & ISO 7240 16 Certified  EVAC PA controller capable of adding 12 zones in the system and expandable upto 400 zones with 14x 4 Audio matrix with full DSP functionality.
8 audio inputs, 4 audio outputs, 4 channel output matrix.
Shall support the following: single line switching or redundant group A/B switching,  amplifier redundany, 4 x 100V audio inputs and  12 speaker line outputs.
Fault, warning and event conditions log. 
Built in message manager for 100 emergency/business calls up to 85 minutes. 18 control inputs and 18 control outputs.
Impedance measurement and Pilot Tone supervision for speaker line monitoring.
  The network controllers shall have a possibility to be  integrated using an interface module which is able to send and receive Audio to and from other Controllers.
Frequency response (ref.  1 kHz) 20 Hz to 20 kHz (-0.5 dB), Signal-to-noise ratio  (A-weighted): Line in to line out: 106 dB typical, THD+N < 0.05%, Crosstalk  (line  level) Line in to line out (0 dB gain): < 100 dB at 1 kHz, Sample rate 48 kHz, DSP processing resolution 24-bit  linear A/D and D/A conversion, 48-bit  processing.
Graphics User Interface software should be considered for Monitoring and control of signal.

Product Details:

IP Audio Interface shall be a universal, IP based audio device supporting VoIP and Audio over IP applications. It shall be used  for bridging audio and contact closuresover long distance LAN and WAN networks. Interface module should have below features:All in one solution for audio transport on IP networksSupervised control inputs and outputsSupports re broadcastingEN 54 16 compliant IP solutionConfigurable as SIP telephone interface

Switch shall be optional Emergecy button that can be installed in the  Call